Profitec E61 Flow Profile / Control Valve

AED760 AED800 Incl. tax Sale
  • Professional upgrade kit to control manually the flow rate in the E61 brewing group.

    Adjustment of the flow rate at which the water in the brewing group hits the coffee.

    This extension gives you the possibility to vary another factor of the espresso extraction in addition to the grind and weight. With a low flow at the beginning of the brewing process, the risk of uneven extraction (channelling) is minimised.

Flow Profile Cotrol Valve E61

For Controlling The Flow Pressure

Professional upgrade kit to control manually the flow rate in the E61 brewing group.

Assembly Instruction:
  1. Unscrew the mushroom with an open-end wrench sized 36mm across flats.
    Caution: Be careful to avoid scratches!
  2. Screw the new profiling valve P1025 in, at the position of the Mushroom.
  3. Unscrew the screw with a 5mm hex key.
  4. Mount the pressure gauge P1026 where the hex key screw was inserted. the Teflon seal of the screw has to be reused. It is recommended to use FDA-approved thread sealing too.
    Caution: Do not fasten the gauge to right, to avoid damaging to the thread.
  5. Close the valve by rotating the bolt clockwise completely.
  6. Place the bushing to point in the desired direction for the closed position onto the spindle.
  7. Screw the ball grip in and tighten it.
  8. Unscrew the purebred-cylinder at the lower brew group with an open-end wrench sized 36mm
  9. Exchange the spring to the supplied P1029-spring
  10. Insert the valve spindle in the purebred-cylinder and reassemble it to the lower brew group.

There are no reviews yet.

Write a review

Your email address will not be published. Required fields are marked *

Related products